收藏本站
2.3GHz to 2.7GHz MIMO Wireless Broadband
RF Transceiver
AC ELECTRICAL CHARACTERISTICS TABLE—TIMING (continued)
(MAX2839 Evaluation Kit, V CC_ = 2.8V, f LO = 2.5GHz, f REF = 40MHz, CS = high, SCLK = DIN = low, 3dB PLL noise bandwidth =
120kHz, and T A = +25°C, unless otherwise noted.) (Note 1)
PARAMETER
SYMBOL
CONDITIONS
MIN
TYP
MAX
UNITS
LOAD Falling Edge Setup Time
LOAD Falling Edge Hold Time
LOAD Rise and Fall Time
B7:B0 stable to LOAD falling edge
LOAD falling edge to B7:B0 stable
Between 10% and 90% of static levels
10
10
100
ns
ns
ns
4-WIRE SERIAL PARALLEL INTERFACE TIMING (see Figure 1)
SCLK Rising Edge to CS Falling
Edge Wait Time
Falling Edge of CS to Rising
Edge of First SCLK Time
DIN to SCLK Setup Time
DIN to SCLK Hold Time
SCLK Pulse-Width High
SCLK Pulse-Width Low
t CSO
t CSS
t DS
t DH
t CH
t CL
6
6
6
6
6
6
ns
ns
ns
ns
ns
ns
Last Rising Edge of SCLK to
Rising Edge of CS or Clock to
t CSH
6
ns
Load Enable Setup Time
CS High Pulse Width
t CSW
20
ns
Time Between Rising Edge of CS
and the Next Rising Edge of
t CS1
6
ns
SCLK
Clock Frequency
Rise Time
Fall Time
SCLK Falling Edge to Valid DOUT
f CLK
t R
t F
t D
0.1/f CLK
0.1/f CLK
12.5
45
MHz
ns
ns
ns
Note 1: Min/max limits are production tested at T A = +85°C. Min/max limits at T A = -40°C and T A = +25°C are guaranteed by
design and characterization. The power-on register settings are not production tested. Load register setting 500ns after
V CC is applied.
Note 2: Two tones at +20MHz and +39MHz offset with -35dBm/tone. Measure IM3 at 1MHz.
Note 3: Gain adjusted over max gain and max gain -3dB. Optimally matched over given 200MHz band.
Note 4: Tx mode supply current is specified for 64 QAM while achieving the Tx output spectrum mask shown in the Typical Operating
Characteristics. The supply current can be reduced for 16 QAM signal by adjusting the Tx bias settings through the SPI.
_______________________________________________________________________________________
9
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
MAX2851ITK+ TRANSMITTER MIMO 5GHZ 5CH 68TQFN
MAX2852ITK+ IC RECEIVER DFS 5GHZ 68TQFN
MAX2870EVKIT# EVAL KIT MAX2870
MAX2904EVKIT EVAL KIT
MAX3524EVKIT EVAL KIT MAX3524
MAX3540EVKIT# KIT FOR MAX3540 DVB TUNER
MAX3541EVKIT+ KIT FOR MAX3541 DVB TUNER
MAX3542CLM+ IC TV TUNER SGL CONV 48LFCGA
相关代理商/技术参数
MAX283X-RD0089 制造商:Maxim Integrated Products 功能描述:INTERFACE BOARD - Bulk
MAX2842ETN+ 制造商:Maxim Integrated Products 功能描述:3.3-3.9GHZ MIMO WIMAX RF TRANSCEIVER - Rail/Tube
MAX2842ETN+T 制造商:Maxim Integrated Products 功能描述:3.3-3.9GHZ MIMO WIMAX RF TRANSCEIVER - Tape and Reel
MAX2850EVKIT+ 制造商:Maxim Integrated Products 功能描述:EVKIT FOR MAX2850 - Boxed Product (Development Kits)
MAX2850ITK+ 功能描述:射频发射器 5GHZ 4Ch MIMO Transmitter RoHS:否 制造商:Micrel 类型:ASK Transmitter 封装 / 箱体:SOT-23-6 工作频率:300 MHz to 450 MHz 封装:Reel
MAX2850ITK+T 功能描述:射频发射器 5GHZ 4Ch MIMO Transmitter RoHS:否 制造商:Micrel 类型:ASK Transmitter 封装 / 箱体:SOT-23-6 工作频率:300 MHz to 450 MHz 封装:Reel
MAX2851ITK+ 功能描述:射频接收器 RF and RFID 射频接收器s - TRANSMITTER MIMO 5GHZ 5CH 68TQFN RoHS:否 制造商:Skyworks Solutions, Inc. 类型:GPS Receiver 封装 / 箱体:QFN-24 工作频率:4.092 MHz 工作电源电压:3.3 V 封装:Reel
MAX2851ITK+T 功能描述:射频接收器 RF and RFID 射频接收器s - TRANSMITTER MIMO 5GHZ 5CH 68TQFN RoHS:否 制造商:Skyworks Solutions, Inc. 类型:GPS Receiver 封装 / 箱体:QFN-24 工作频率:4.092 MHz 工作电源电压:3.3 V 封装:Reel